#Dsc pc1550 programming manual how to
#Dsc pc1550 programming manual manual
#Dsc pc1550 programming manual code

Just to be safe, also try this with a simple piece of wire. If the zone remains open, then either the zone is somehow misprogrammed, or the panel is damaged. To verify that your zone inputs are good, simply take a 5600ohm resistor (thats green blue red for the first three stripes) and attach one lead to the zone input, and the other to the common. Lather, rinse and repeat with the rest of your zones wiring. the contacts are good, and the wire is good) the meter will beep. Disconnect one leg of the zone wiring that you are testing and put one meter lead on the loose wire end, and the other on the wire where it's joined to the wire. It's the one that beeps when the test leads are shorted together. Most multimeters have a function in their resistance test function for continuity. The 'ready' light would come on fine before, and opening/closing the doors, would light/unlight keypad accordingly before I had this panel box reset.(all I needed was the code).Is it possible that the 'reset' that I sent the panel off for could have damaged it?.im at a loss

#Dsc pc1550 programming manual manual

In normal running mode (pushing the # key), with all doors shut and motion detector area still.Im Still just getting zone lights 1-4 staying on, and trouble light on (this is the battery backup trouble light.the manual says that the system should still work even when that light is on) I even bypassed each zone separately, to see if maybe that particular zone may be bad, wired bad, etc.(that would work as a simple troubleshoot, right?).still nothing.no 'ready' light during any of the separate bypasses So far, as of today, Ive thoroughly went through EVERY section on programming, checked and doublechecked all the connections on the panel, rewired all the zone wires, and have done everything I can think of to check this system.Still no 'ready' light ever

#Dsc pc1550 programming manual how to

and know how to use it (basically).can you explain to me exactly how to test the continuity on the zones? Otherwise Im going to have to spend a grip to get this unit replaced. Now the system is just lit up on all zones and the alarm goes off every 5secs, so I had to unplug it again.

#Dsc pc1550 programming manual code

It says you cannot change the master code of 1234 from the * 5 screen. So What the manual shows doesnt seem to be accurate. What am I doing wrong?ДЄlso the * 5 (MasterCode) to add or change User codes, well did that and then 1 and then a new code, and it changed the default master code of 1234. I just simply cannot enter the installer programming section. But everytime I try the * 8 (Installer code of 1500) I just get a long beep after I enter the code, no lights light up. After doing that I was able to get into some of the options like * 6 (MasterCode) and then the user commands. All zones seem to be in order but could not get a hold of the master code or installer code. I bought this house about 6months ago and after a few of my renovation projects have been completed I came to the Alarm system they never used and the plug for the panel was out.